Nov 06, 2022 Leave a message

Electroplated plastic plated

The plated parts of plastic plating are easy to float, and the place in contact with the hanger is easy to be burned because the specific gravity of the plastic is small, so it is easy to float in the solution.

The shape of the lampshade is like a small disk, the inner surface is recessed, there are two small holes on the side, and only two small holes are used to plate with a copper wire.

Due to the release of gas in electroplating, the lampshade is easy to separate from the copper wire, and the copper wire is also light, which is not enough to immerse the lampshade in the solution. Later, a heavy object was attached to the copper wire, which solved the floating problem. The contact point between the copper wire and the lampshade is charred and the plastic is exposed, which is caused by poor conductivity.

Solution: In order to solve the problem of floating and conductive plastic electroplating workpiece, we designed a special fixture. The clamp has a certain weight, no longer floats after the lampshade, and then uses two wide conductive sheets to jam the hole of the lampshade, so that the current is uniform everywhere, and the contact point will not burn.


Send Inquiry

whatsapp

Phone

E-mail

Inquiry