Bumper Injection Tooling
video

Bumper Injection Tooling

This bumper injection tooling is made for bumper of project N520 JMC Ford, which is a Ford Transit modified van. The bumper mould was completed in 3 months and another 3 months to delivery after sampling and modification for mass production at Huaxiang Group.
Send Inquiry
Product Introduction
Tips for Bumper Tooling Design

 

A great mold making factory must have its great team for mold design. Years tooling making and research provide us experiences on design and we are going to share some technique tips for bumper injection tooling here.

 

1.Rate of the big lifter height and push-pull block stroke at bumper side

product-354-357

Diagram above shows basic configuration of inner-parting bumper ends, while the height H of the big lifter directly infects pull deformation.The bigger push block stroke L,the bigger H is needed,otherwise pull deformation fails or product gets damaged.

product-869-159

Figures in the table above shows H:L rate mostly ≥9 according to several cases of bumper injection toolings we made before, while we suggest H:L≥10 that kink marks can be avoided.If existed kink marks need to be solved,then part wall shall be reduced at relative area(black line indicates).

 

1
2

2.Bumper radar hole

3
4

There are two ways to make the radar hole-as part of product by injection molding and the other stamping sololy, with different advantages and disadvantages.

 

Radar hole made with bumper product could save time but produce a weld line,and meanwhile some radar holes' draft angle differ from product's. Thus a core pulling mechanism should be set for the radar hole to draft which effects mold stability.Radar hole made by stamping off course gets one more process for bumper production with more time and cost,though weld line problem could be ignored.

 

3.Dog house at slope

product-1089-412product-610-622

 

Figures show dog house with 0.8mm bottom wall thick is set at side slope and 1.7mm in distance from the facing inclined surface which could result in sink marks on product surface, so normally we make part of dog house side perpendicular to the slope as the last figure indicated.

 

5
6

4.The big insert

product-328-255

The bumper mold tooling big insert solution that to make a holding mechanism on the big insert ejector's guide pin&bush not only supports the big insert ejector block but also prevents guide pin deformation and guide bush abrasion.This kind of solution is simply set to operate while costs little, moreover outside the mold which can be applied easily for both new and used mold for function as said.

Hot Tags: bumper injection tooling, China bumper injection tooling manufacturers, makers, Bumper Moulding Tool, Bumper Injection Tooling, bumper tool

Send Inquiry

whatsapp

Phone

E-mail

Inquiry