1. Plasticizing pressure: (back pressure) When using a screw injection machine, the pressure received by the melt at the top of the screw when the screw rotates and retreats is called plasticizing pressure, also known as back pressure. The magnitude of this pressure can be adjusted by means of an overflow valve in the hydraulic system. In the injection, the size of the plasticizing pressure is with the design of the screw, the quality requirements of the product and the type of plastic and need to change, if these conditions and the speed of the screw are unchanged, the increase of plasticizing pressure will strengthen the shear effect, that is, will increase the temperature of the melt, but will reduce the efficiency of plasticization, increase counterflow and leakage, increase the driving power.
In addition, increasing the plasticizing pressure can often make the temperature of the melt uniform, the mixing of the pigment uniform and the discharge of the gas in the melt. In general operation, the determination of plasticizing pressure should be as low as possible under the premise of ensuring the quality of the product, and the specific value varies with the variety of plastic used, but usually rarely exceeds 20 kg/square centimeter.
2. Injection pressure: In the current production, the injection pressure of almost all injection machines is to the top of the plunger or screw to the plastic
The pressure applied (converted from the oil circuit pressure) shall prevail. The role of injection pressure in injection molding is to overcome the flow resistance of the plastic from the barrel to the cavity, to give the melt filling rate and to compact the melt.




